Finally got it figured out. The older, 9,000 Btu 'test' unit was not enough to cool down on a humid, mid 90's day. I found a new 12,000 Btu unit at Pep Boys for $479. They have a 9,000 Btu unit for $379. I know, alot more than those cheap, 5,000 Btu window units, BUT - no holes, no screws, very quiet, lightweight, etc..
The newer, 12k unit acutally uses LESS electricity than my old 9k unit did: 965 Watts, 8.5 amps running and about 15.3 amps starting, using a delayed start, rotary compressor. The newer unit is also smaller and lighter, and comes with built-in Ground Fault interuption circuit. It has HEPA and Carbon filters, as well as wheels to wheel it up and down the dock.
The newer unit DOES NOT NEED A CONDENSATE DRAIN HOSE. It can clear 64 pints of water per day thru the evaporative, hot air discharge. Soooo, no holes in your boat!
The plastic window flanges that come with it (they give you three) can fit into the normal sliding windows, or can be cut to fit the TomCat's screen flanges on the forward bunk ports. I just cut out an upward offset hole in a piece cut to fit the screen template and glued the tube fitting to that. Very easy to place and remove from the window.
Although I don't foresee trying to use the A/C during a storm at sea, I'm trying to figure out how to put a cowling over that exhaust setup to deflect water.
Anyway, the 12,000 Btu is working well without any extra insulation at this point. The whole unit can easily be removed and wheeled down the dock to the truck for winter.
John
The newer, 12k unit acutally uses LESS electricity than my old 9k unit did: 965 Watts, 8.5 amps running and about 15.3 amps starting, using a delayed start, rotary compressor. The newer unit is also smaller and lighter, and comes with built-in Ground Fault interuption circuit. It has HEPA and Carbon filters, as well as wheels to wheel it up and down the dock.
The newer unit DOES NOT NEED A CONDENSATE DRAIN HOSE. It can clear 64 pints of water per day thru the evaporative, hot air discharge. Soooo, no holes in your boat!
The plastic window flanges that come with it (they give you three) can fit into the normal sliding windows, or can be cut to fit the TomCat's screen flanges on the forward bunk ports. I just cut out an upward offset hole in a piece cut to fit the screen template and glued the tube fitting to that. Very easy to place and remove from the window.
Although I don't foresee trying to use the A/C during a storm at sea, I'm trying to figure out how to put a cowling over that exhaust setup to deflect water.
Anyway, the 12,000 Btu is working well without any extra insulation at this point. The whole unit can easily be removed and wheeled down the dock to the truck for winter.
John