Search results

Sold

Price reduced to $24,900 !!!

It appears that rearview mirror adhesive...sold at auto parts stores...is popular from what my search produced. Some folks got new latches from the factory.

Shame on me.....should have searched before asking. There is lots of good info there!

I pushed a little too hard when closing a sticky side window and the latch unit came off. Anybody know what glue/ adhesive is used on this part? Thanks.

2008 19' Angler with 2007 Honda 90 FI motor and Venture single axle trailer. Includes: Swim platform w/ ladder, drop curtain, grab rails in cabin, Lowrance LMS 520c depth/ GPS, porta potti (new), permatrim, Bennett trim tabs, Angola full boat/ motor cover, Dickinson propane heater/ fireplace...

I have a Honda 90 on my 19' Angler and it almost feels overpowered. As long as your not heavily loaded, the 60 should do the job.

There are two cracks in the gray cockpit floor covering in my 2008 19' Angler, as if the covering is peeling up. They don't go down into the fiberglass...you can slip a knife blade on the flat under the flooring. They are approx. 12 to 18" long. Any suggestions?

Thank you Marc! Just the info I was looking for.

Roger, The rear tube rail of the rack that connects to the sides of the motorwell is at least an inch or more too short to slip far enough into the end fittings for the set screw to make contact. My solution is to shim the brackets that fasten to the sides of the motorwell to decrease the span...

I recently bought the overpriced C-Dory factory cooler rack that doesn't fit my boat despite what the factory said....it's too short. After cleaning the goop off with solvent, I proceeded to devise a "make fit" solution. My question is...what's the best cooler for this rack...I've searched the...

Thanks guys! Just what I wanted to hear. The grandkids are gonna love it!

I need some advice on the best way to fasten a ski tow line to my 2008 19' Angler. There are two screw (bolt) eyes on the transom. Are they strong enough?

I vote for the BOSE headset as well.

Thank you all for the good info! I just checked and the top of the Permatrim on my motor is 1" below the bottom of the hull when parallel. I may try raising it one hole in the springtime. I'd like to try the Quicksilver 14 pitch ss prop....can someone give me the proper description and suggest a...

My Honda 90 is mounted on the transom in the second hole down from the top and I have read that the Permatrim should not have water flowing over the top...mine does. Where have you other 19' Angler positioned your motors?

The Honda Outboard web page has performance data for the 19' Angler with the Honda 90 engine, if that helps.

I finished the Permatrim install on my Honda 90 and got out on the lake over the weekend for a tryout. It seems to improve control and handling at all speeds and reduces the "porpoiseing" that that my 19' Angler likes to do. Unfortunately, I still have to trim the engine right down on the stops...

Sea Wolf did a much better job than I did explaining the droning noise. My canvas bulkhead reduces the noise level slightly. Arniehuff, Thanks for the input...you may have saved me some time and aggravation getting this issue resolved. Tsargent, I have my Permatrim. As soon as my new prop...

Tsargent, The droning sound is engine noise that is "captured" in the enclosed, hard wall cabin...happens around 3,000 rpms. I now keep ear plugs on the boat. Also, an update, had her out on the Hudson River the other evening...calm water to a ripple. I was able to try out the upper end of the...