Hello all. I am planning to install a garmin intelliducer over the next few days. I plan to use a "stern saver" for the transducer installation so I will not screw into the hull "using 4200" Any suggestions on attaching the wire for the transducer? I plan to run the wire into the splash-well drain and down to the transducer. I do not want to use screws into the hull so any suggestions would be appreciated. i feel that I only need two or three contact points. My thoughts were to use zip tie squares (at least I think that is the name). I have used them in the interior with two part epoxy and they have worked great. My concern is that the plastic may deteriorate in the open and will be difficult to reattach new squares.
As always thanks in advance.
Coach
As always thanks in advance.
Coach