I've had the benefit of running the 22 hull with the original design power (Our 1991 cruiser w/Johnson 70 2-stroke) and modern power (2007 Angler w/Honda T-40's). The old hull felt more nimble and light, and the running attitude was much more level. Without trim tabs I could easily get the bow down for chop conditions. This despite the fact that the Angler handles transom weight better due to more forward center of hull weight. While I feel the Suzuki is a fine motor, the 90/115 versions, as well as most of the other 4 stroke singles or twins, are simply heavier than the hull was designed for. Notice the exaggerated bow rise in planing photos of 22's, including one on this thread, and you'll see what I mean. The stern just digs itself in like it was not designed to do. I personally desire backup power, and therefore included kicker weight in the overall transom weight when comparing power options. My owner's manual (for a cruiser) recommends you not exceed 500# total transom weight, including engines and batteries, or balance/handling can be adversely affected. Do the math and decide for yourself. My choices came down to an E-Tec 90 with kicker or the twin Hondas, virtually identical total weight. The new Honda 90 V-Tec was my second choice for a single. My wife and I love the new boat but don't like the bow-up planing attitude; I have twin Permatrims to install that I hope will improve the situation. by providing 2-3" total lift. BTW I get 32MPH moderately loaded with 12" props, and can get 30 with a very heavy load, running 80HP. Mike.