2006 23 Cape Cruiser, $52,000 (Bella Vista, AR)

G

Golerud

New member
The time has come to part with our boat SLOGO. Age and the infirmities that go with the older age are upon us.

2006 23' Cape Cruiser, asking $52,000. The boat is presently located in NW Arkansas.

1. Engine is a 2006 Yamaha 115 with 120 hours, w/ 3 props, 13, 15 and 17 inch pitch
2. Kicker engine is a 2012 Tohatsu 9.8 w/electric start and tilt. Included is a tie bar to the main engine for remote steering.
3. Lenco electric trim tabs
4. Garmin 4210 Display with GPS and depth finder
5. Garmin HD radar
6. Icom mdl 602 VHF Radio
7. Tall stainless steel radar arch with rod holders
8. Sony stereo with Bose speakers
9. Delta anchor with 15' of chain and 150' of line
10. Simpson/Lawrence windlass
11. Full cockpit enclosure
12. Fuel tanks have new sending units and have been raised 1/4" off deck to allow drainage.
13. Wallas mdl 800 stove/heater
14. Rear port and starboard hatch covers have been replaced with new Imtra covers
15. Full sunbrella interior window covers with roll up sides and snap on front and rear cabin windows and door.
16. Custom spice rack, paper towel holder and mahogany storage cabinents
17. Porti Pottie
18. Dry Deck for cockpit
19. one complete set of slightly used Corinthian brand marine carpet set for cabin and cockpit plus one complete new unused set.
20. Swim platform with 3 step ladder
21. Ritchie Helmsman compass (Not Installed)
22. 2 new group 24 AGM batteries purchased at Cabelas in March 2014
23. 30AMP shorepower setup with HD cord.
24. Misc. Dock lines, Fenders, rod holders
25. Welcome Aboard Brand V-Berth size Sleep system with upgraded sheets.
26. LED Lights in cabin and anchor light.
27. New cockpit storage cover. Never used as boat has been stored inside when not being used.

TRAILER
King saltwater series tandem axle roller trailer 5,400# capacity
2 5/16" ball
Electric over hydraulic brake controller
Disc brakes on both axles
Dutton Lainson TW 9000 electric winch with Strap. No Cable
4 Goodyear Marathon tires new in spring of 2013
Spare tire and wheel.

For photos, please visit our album SLOGO in the photos section

:cry:
 
I would suggest that all look at the Slugo Album. There is some beautiful custom cabinetry pictured in the "interior" photos!
 
Wow ... nice boat.

...now say that three more times!

As Dr. Bob said "nice cabinetry." (somewwhat understated)

Check it out.

Best,
Casey&Mary
 
When I was preparing the for sale listing for our boat, I forgot to list the S1000 autopilot I had installed.

I appreciate the comments about the cabinets I made for the boat. They consist of two separate units and are easily removed if ever a need to gain
access behind them.

Gary
 
I have added a photo to our album of our 2004 Dodge 3500 truck. When we sell the boat, the truck won't be needed so it will also be for sale. Its equipped with a Cummins diesel, 6 speed manual transmission and lots of other goodies.

We will be leaving Arkansas in a couple of weeks and heading to Yellowstone for a brief visit and will then spend 3 weeks on Lake Pend Oreille in northern Idaho. If someone out west is interested in a great boat and wants to see it, PM me and I will provide details of where and when.

Gary
 
Travel time has come. We will get all loaded up tomorrow and leave this Arkansas 95 degree heat. We are headed north to Nebraska to visit with our daughter and then west hoping to be able to handle the altitude at Yellowstone for a week or so. If my COPD isn't to bad at 7800' altitude we will spend at least a week there. From there we are going to spend 3 weeks at Garfield Bay on Lake Pend Oreille in northern Idaho. Elevation there is only about 2000' feet so I shouldn't have any breathing problems.

SLOGO is still for sale but it doesn't make sense to me to leave it sitting, so will enjoy it while we still have it and are able to use it.

If anyone is interested in seeing the boat while we are enroute, or just want to meet and visit, please PM me or call me at 479-366-2786. Hopefully we will get to meet some C-Brats along the way.
 
Wish you were passing by my area,Pennsylvania would like to see your boat. If you are in future travels please let me know,that is the boat im interested in.Sometimes seeing it makes you buy it.Enjoy your travels, Larry.
 
Hi Gary & Sherry, great seeing you last week at Yellowstone Lake. You have a gorgeous boat. Someone is going to get a very well equipped and well cared for boat. Folks, if you are thinking about a 23 or 22, you should check out this boat. As of this posting, Gary is in Idaho for several weeks, if you are in the western US and considering this boat now is a great time to see it before it goes back to Arkansas.

Safe Travels,
K&L
 
We have arrived at Sand Point, Idaho. We will spend the next 3 weeks at Garfield Bay on Lake Pend Oreille. It's a beautiful area. For those of you in the PNW who may be interested in the boat, now is the time to come take a look. Cell phone service is just about non-existent on the bay so if you wish to contact me, send a PM as I will be able to get on the Webb every few days or leave a message on my phone (479-366-2786) and when we come back to Sand Point for supplies I will check for messages.

We don't really want to bring the boat back to Arkansas as it's not really C-Dory country. So, if interested, we will consider any serious offer.

Gary
 
We are getting close to the end of our stay on Lake Pend Oreille and I would like to sell our boat before we return to Arkansas. Therefore, we are dropping the price $4,000 to $48,000.
 
Please somebody buy this so I can stop being tempted! (I can't easily handle the additional 1,000# of trailering weight, but if I could.....)

Alternatively, Golerud, would you consider doing some cabinetmaking on my 22 this winter? Gorgeous work :thup
 
Thank you for the compliments on the boats cabinets. I spent a lot of time on them and they really work well. I'm old and retired but my son is a master craftsman and would be more than happy to do some work for you. Check out his website at www.dovetaildesigninthetetons.com He also does stainless steel work.
 
Our boat "SLOGO"has been sold. It has been a wonderful trip and we have had a lot of fun and met many wonderful people, some in person and many others only by reading their posts on this site.

I have learned a lot and appreciate the willingness of so many individuals to offer advice and their expertise whenever I have had a question.

Thank you everyone.

Gary
 
Back
Top