Search results

  1. A

    Trailer tires pressure

    I have not weighted the boat and trailer, never found a convenient way or time to doit. Getting the boat out and back in is a bit of an undertaking. I think ~ 7,5 K lbs is a fair estimate with little fuel and no water?
  2. A

    Trailer tires pressure

    Ah! I found something interesting looking at the Carlisle Tires Trailer Tire Service Guide Line, Under an identical chart that the one for Goodyear Endurance there was this paragraph: " The above table DOES NOT endorse the reduction of air pressure. It is to be used as an exampleof the...
  3. A

    Trailer tires pressure

    Salmon Fisher, I downloaded and printed the Load/Inflation chart and looking at it (first chart up top for ST tires) I get a bit confused. For the ST225/75R15:assuming a total load of 7500 lbs and assuming again it would be equaly distributed on each four wheels, the chart gives me a recomended...
  4. A

    Trailer tires pressure

    I now have 10 ply rated tires on the trailer, indicated max pressure is 80 psi. What is the consensus on this? Always max pressure no matter what? Season and temperature dependant? Trailer loading dependant? What range to stay between if less than max inflation? I'd like to get started on the...
  5. A

    Moving up from a CD22 but where and when does it stop?

    I know what you mean SJ I went from 12 to 16 to 27 to 37 (15 years worth) and now very happy with 25.
  6. A

    Jabsco 18590 series macerator sewage pump issues

    Are you married Bob? :wink:
  7. A

    Jabsco 18590 series macerator sewage pump issues

    Two Jabsco pumps one after the other have been nothing but problems, finally did the same than Boris and got the Shurflo 3200. perfect replacement fit and no issues whatsoever for the last 2 years or so! The hair? Someone probably cleaned a hairbrush over the toilet..
  8. A

    CD-25 Steering

    "Try disconnecting the steering cylinder from the motor. Swing motor lock to lock by hand. if stiff there is your issue." ... I would agree with that being the first thing to check with motor trimmed all the way down if that is where you are mostly noticing the problem. IF too stiff, there are...
  9. A

    Honda 135 outboard on a 25'

    Is that with a light or heavy boat? What prop do you have on?
  10. A

    same here

    Oops! Sorry, should have posted under C-Dory with 135..
  11. A

    same here

    A tad over 5000 rpm? That's what I get with my yamaha F150 and the original alu. 15x151/4 prop but that is fully (over) loaded for extended cruise. I should really switch to a 13 pitch but the one I have as a spare make this annoying rattle at low rpms, drives me crazy.
  12. A

    Mysterious Brown Liquid

    Could it be hydraulic steering fluid?
  13. A

    How to loose a caliper on your trailer disk brake system..

    Use of Loctite 262 is specified by Tie Down Engineering for the caliper pin. It is a part subject to a lot of vibration while brakes are being applied.
  14. A

    Short video from factory

    https://www.facebook.com/CDoryBoats/vid ... 8982/?t=56
  15. A

    Lake Powell

    drastic measures: https://tucson.com/news/local/feds-will ... 7e965.html
  16. A

    Lake Powell

    Duplicate
  17. A

    Lake Powell

    Bob, thanks for this wealth of information and your generous offer, I will be looking into all this. Alain
  18. A

    Lake Powell

    Bob, thanks for this info on Willow Beach, looks like a good alternative to Lake Powell. I assume one could go South all the way to BullHead City? Have you done it yourself? Any good places along the way to drop the hook for the night?,Side channels etc..? Any Charts or maps of that stretch you...
  19. A

    25' cruiser dimensions

    32 L 9.4W 10.6 H
  20. A

    25' cruiser dimensions

    32 L 9.4W 10.6 H
Back
Top