Search results

I will add that not all electric brake controllers are compatible with EOH actuators. For example, the aftermarket Reese Brakeman Compact controller that I have mounted under the dash of my F250 and that I've been using successfully for years when hauling rental equipment with electric brakes is...

Oops I am referring to the sump in the back of the CABIN, to the starboard side of the cabin door. I’ve been told the newer 22s don’t have this sump so this may not apply to the OP. The sump in the back of the cockpit IS cored, though there the core is thinner than the rest of the hull. You...

On my 1999 that sump is not cored and I'm planning to mount the same Hawkeye transducer in that location. I got this idea from Sunbeam, who has done the same and reported good results. I plan on sealing the slot that drains from the cockpit into the cabin sump and moving the bilge pump that was...

1) Two sources that can give you info: Greg at NMI: (360) 389-5351 - can tell you who made those parts and Advantec Marine at 1 604-607-0091: likely the ones who made the parts and can sell you a new door. I ended up surfing the web to find a new door latch for my 22'. 2) I just went through...

Thank you Karl. This looks very much like what I envision needing. I notice your kicker is mounted higher than the transom top edge. What length is the kicker motor shaft and how far out do your trim tabs protrude? My motor has a 20" shaft and my trim tabs protrude 12-5/8".

I need to build a bracket so that my kicker has adequate clearance from the trim tab vane. For those of you that have a kicker and trim tabs, how far away does the motor need to be from the protruding edge of the trim tab? Obviously I want the kicker as close to the transom as possible. Thank you.

I also have Seastar hydraulic steering. What benefit does their $600+ cable tie system provide over a simple connecting rod?

I’m looking to hear how others have mounted their controls for controlling both main and kicker from the helm. I’m about to purchase a Mercury 115hp main and a Mercury 9.9hp kicker (remote steering and trim) and need to decide on controls. The main and kicker will be tied together with a...

Make sure that whatever you use is fire retardent.

Is there someway to get pictures and albums to get added in the reverse order that they are now? In other words, when you create a new album it gets shown at the end, instead of the beginning, of the list of albums. Same for adding photos to albums - if they could be added at the end of the...

This is what I do: Media - Your albums - <click on the album you want to add to> At this point you can see that particular album and then click on "Add Media". I have found that when you add media to an album it gets added to the beginning of the album, not the end. So if you want to document an...

Media - Search media - Keywords: kicker, Posted by: colbysmith

I decided that while I had the roof in the shop I would go ahead and prime it for painting later. I did final sanding with 320 grit sandpaper and then primed it with AlexSeal primer. The primer was thinned with the proper thinner and applied with the proper roller as per the AlexSeal directions...

Done. Well, except for sanding and fairing. The new sections consist of two layers of 1708 with additional layers at the edges and corners. Note that while the roof section of this hightop is 4" higher like the factory high top, it is longer than the factory hightop, meaning the front angle is a...

Masonite forms in place for laying up the corner gaps.

Front section has been laid up.

Front section has been laid up.

I used 1/8" smooth masonite to make a curved form to close the front of the roof.

I built a wooden cradle to hold the roof off my work table so I could work on it without distorting its shape.

Once the walls had been extended I reinstalled the roof top.