Search results

Fuel filter?

I would think that is a separate curcuit. Like Charlie said check your grounds, any fuses and connectors.Did trim work before the warning lights flashed? You may also want to try a light tap on the trim motor with a rubber mallet or something that won't chip paint. I have seen this work on...

Sounds like impeller problems. There must be an over temp sensor that caused a shutdown. After engine sits for a while try a short crank if it turns over you have a good idea what the problem may be.

Ok yes, thanks for the advice all. I will leave rail as is.

Yes, thank you Charlie, I'm aware that the rub rail is attached with rivets but I'm not sure if the entire rail should be sealed to the hull so water will flow over it not through it. I sealed the new rivets but I just don't like the fact that water could penetrate the hull in this area and it...

I had a small section of the rub rail coming loose on the port side stern and after reattaching I wondered what is actually sealing the rub rail to the hull?

I'm curious why fish farms would raise a non native species like Atlantic salmon rather than coho or spring salmon? :?:

Glue in a plug,wait till tomorrow, drill new hole! :thup

A simple and cheap option for your controls is a trolling bar attached from your main to the kicker and an electronic throttle control for your kicker. :smile

Yamaha :thup

Wow Sam your moving at a good speed! Next fuel stop is Hartley bay, I was just down at butedale and louis has no fuel. Hope there is time to stop at bishop bay, it's unfortunate to have to race past all the sites. Good luck with the Dixon entrance.

Nice mods. One thing I did that worked well for me is a couple of holes in the rear corners for drains, if your cleaning fish this is a must, tilting the table a few degrees aft is also a good idea to avoid wearing any fish cleanings. Also I had good luck with a couple of kuuma barbq mounts...

C dory owners who already have permatrims will agree that they are an excellence addition and very helpful to lower the bow in the chop to reduce pounding. Getting on plane at 10 knots is nice too. There is a small reduction in top end speed and caution is needed when running in a following sea(...

Wow you guys are living the dream! Glad to hear the new wallas is working well. Just wondering how far south your planing on going. I'm planing on being in Rupert and possibly ketchican for may long weekend maybe we'll cross paths somewhere this summer. I hope to be on the coast till the end of...

Just for your info, I have the same magic tilt trailer and purchased a set of ST 175-80-r13 tires load rating c. Max load 1360lbs at 50 psi. They are the recommended tires for this trailer and have been excellent for the past two seasons towing a few thousand miles each year with a fully loaded...

I too have had the best sleeps ever aboard my 22. Last summer while working at a mine in central bc I lived aboard on Francois lake for 3 months. This was great and reminded me how little is really needed to be happy in life. I feel that people nowadays clutter up their lives with stuff, and...

Bridma's right I also catch myself staring and dreaming of the next adventure all the time. When trailering you'll be amazed how many others stare and at fuel stops its a given that at least one person will approach you and ask about your boat.

Congrats on the new to you boat! Now for the fun part, making it your own with the custom mods of your liking. A whole new world of cruising destinations is now available to you! Good luck on all your cruising adventures! :thup

Sorry to hear about the wallas, just wondering if it's something that can be repaired onroute. With all the experience on this site with wallas failures and repairs it may be possible for us to help from here. What do you have for spare parts and troubleshooting tools? Did you let the smoke out...

You need a diode to avoid any current damage to your panel. This should already be installed in your panel controller if you have one