Search results

Bob, I used 5200 a few days ago for putting down the tank strips to the floor and noticed that you recommended 4200. What is the difference between the two? Vern

I should have started a new thread instead of adding to a different topic altogether...so here goes. I have tried searching in our library, but have not found if twin 50's (what I have) or 40's require two separate fuel filter/separators or just one adequately sized one? I have a Racor...

I have tried searching in our library, but have not found if twin 50's (what I have) or 40's require two separate fuel filter/separators or just one adequately sized one? I have a Racor 120R-Rac-01 which shows max flow of 60GPH. According to Racor's general rule of thumb: h.p.x.36 = fuel flow...

It would have been even better than a Powerboats report to have had a 90 Etec, 90 Honda, 90 Suzuki and 90 Yamaha do this test run...plus give press to the CD 22. This would definitely show the public "where the rubber meets the road" on efficiency.

Thanks to all who have posted. This gives me a starting point and yes, my mechanic has offered to swap props for the right one. I generally just fish the ocean here in N CA and am not a WOT runner, but prefer to have hole shot when and if I need to make it over waves at our local port...

Hello All Twin Honda 50 Owners: I know there are a lot of you out there and since there are so few twin 50 Yamaha owners (which I am one), I need some advice. On my CD 22, I am running 14" pitch SS props, but when I test ran the motors, I found I could only get 4700 RPM's which my mechanic...

Seapo, what size pitch do you have on your 40's and are they alums or SS? Vern

I purchased my '03 CD 22 in October and have finally gotten the motors tuned. They only had 100 hours on them but were not really babied as i generally do to my motors. Wow, having had EFI 4 strokes in the past, I did not the expect Yami carbs to be so sensitive. I was told that you should...

Hello, I am somewhat new to this forum and have twin 2003 carb 50 4 stroke Yami's with 14" ss props on a CD22. I took my boat for a test run last week for the first time and saw that my max rpm was 4700 rpm, somewhat below the recommended 5000 - 6000 rpm. I have the normal load of fuel (50...

Just finished a custom fish cleaning station that fits snug into the splashwell of my newly acquired CD22. It has a 2" lip that secures it to the back splashwell and is made out of a white composite/aluminum board. It is 30"L x 10"W x 10" D and drains thru a 1" bilge hose to a 2nd splashwell...

I just received my one piece Sunbrella cover from Angola Canvas in IN. Ph: 260.665.9913. They did an outstanding job adding a boot to include my radar arch and 6 shotgun holders. Also, they included 2 outboard covers for the twins and were much more reasonable than local or WA canvas shops...

I have used these downriggers for 6 years now and have had very little issues with them. Big Jon replaced the orginal extensions at no cost because they corroded due to poor quality. I opted for the longer arms and they work fine. You can substitute tie wraps for the springs (which do tend to...

Congratulations to Triple J and LBarrett...and thanks to others for the welcome! I hope to have my album up once the arch is installed. Vern

I too am a newbie to C-Dory and took delivery of my '03 CD22 3 weeks ago. It has twin 50 Yamas and is very clean. I have been working on installing an arch, inside roof rails and a few other miscellaneous items and then will give it a first trial on a lake nearby my home here in Lincoln, CA (N...