seagrits@aol.com
New member
Evening all,
I have a wallas 95d. When I purchased the boat, it was inoperable, and after a little investigation I found the diesel tank full of some really bad fuel and the fuel pump gummed badly too. I was able to get all of that taken care of, and the stove worked perfectly for several trips.
Recently, it has a different symptom that I can't figure out. Here's the sequence:
1. Turn on, green power light is on and not flashing. (Voltage is good)
2. The audible noise of both the blower and the pump are apparent.
3. The sound of the flame being ignited.
4. Heat is felt over the left burner.
5. Red light never turns solid but rather goes to flashing failure mode.
I'm suspect of either a board problem, or maybe a device that tells the board that there is flame. What would this device be and how can it be tested? A milliamp signal from a thermocouple,, or perhaps a millivolt signal from a flame rod? Also, where does this device connect on the board? Is it possible the burner could just need cleaning?
I'm kind at a lost with this thing so any and all pointers are appreciated.
I have a wallas 95d. When I purchased the boat, it was inoperable, and after a little investigation I found the diesel tank full of some really bad fuel and the fuel pump gummed badly too. I was able to get all of that taken care of, and the stove worked perfectly for several trips.
Recently, it has a different symptom that I can't figure out. Here's the sequence:
1. Turn on, green power light is on and not flashing. (Voltage is good)
2. The audible noise of both the blower and the pump are apparent.
3. The sound of the flame being ignited.
4. Heat is felt over the left burner.
5. Red light never turns solid but rather goes to flashing failure mode.
I'm suspect of either a board problem, or maybe a device that tells the board that there is flame. What would this device be and how can it be tested? A milliamp signal from a thermocouple,, or perhaps a millivolt signal from a flame rod? Also, where does this device connect on the board? Is it possible the burner could just need cleaning?
I'm kind at a lost with this thing so any and all pointers are appreciated.