Side Guides

Wandering Sagebrush

Wandering Sagebrush

Free Range Human
Joined
Jan 21, 2005
Messages
2,791
Reaction score
2
Location
North East Oregon
C Dory Year
2005
C Dory Model
22 Cruiser
Vessel Name
Constant Craving
When Diana and I were towing Constant Craving all over the backroads of eastern Oregon and central Idaho, I had the lag bolts on the right side guides back out and allow the guide to drop down on the trailer. I just bungied them up and got home safely.

Anyone else had this issue?

I haven't made up my mind whether to replace the lag bolts with a slightly larger size, to use a counter set carriage bolt with the head well below the surface of the guide. Anyone have an opinion?

Steve
 
while working on my trailer I had the same problem on one guide. I just redrilled the hole over 1/2 a inch and re-screwed the lags in. the only other option is thru bolts and you would have to counter sink the heads so they would not scratch up your gel coat. All lags are going to fail at some point becasue in salt water they rust and that makes them loose and rots the boards. So unless you get plastic boards and stainless steel lags ypu need to keep a eye on this thing.
 
I've had this happen several times on the road. The first time I gooped in a bunch of 5200, but that didn't work. Then I bored out the holes oversize and filled them full of epoxy. After re-drilling pilot holes, I coated the lag screws with more epoxy and and installed them. So far, so good.
Al
 
Thanks for the feedback. I think I am going to go with the epoxy fill and redrill technique.

Steve
 
IMHO, the real solution for the lag bolt problem is to install smooth headed carriage bolts with the locking washer set up (looks like a washer with a square hole and spikes pointing downward) that locks the carriage bolt so it won't turn on the inside of the rail, and then you install a fender washer and nylock nut on the outside. This gives you a through-bolt set up. Then you get to recover the guide ons with new carpet, too.

Since the threads of the carriage bolts will be sticking out a bit, cut them off flush or put plastic or rubber tubing on them to eliminate the "meat Hooks". I like to use clear plastic Tygon tubing on mine, as it leaves some of the extra threads intact for disassembly and re-installation, should it be necessary.

Lag bolts fall out with rot, in either salt or fresh water, period!

Joe. :teeth :thup
 
Pacific trailer sent me load guides exactly as described by Joe. The nuts for the carriage bolts are not nylock. Pacific supplies a flat washer, lock washer and nut, all stainless steel. We used lock tite on everything we put together - blue as I recall as it allows things to be taken apart without heating.
 
helm":3q00xuw2 said:
Pacific trailer sent me load guides exactly as described by Joe. The nuts for the carriage bolts are not nylock. Pacific supplies a flat washer, lock washer and nut, all stainless steel. We used lock tite on everything we put together - blue as I recall as it allows things to be taken apart without heating.
Click to expand...

I fiogured out the carriage bolt idea a few years back after going through all the lag bolt problems myself, including going to a larger size, moving them, filling the holes with epoxy filler, etc.

This is the third time I've mentioned the carriage bolt solution.

The Locktite is a good idea!

It's good that we can share these ideas here and avoid some of the wasted time figuring everything out over and over again as individuals.

Joe. :teeth :thup
 
Back
Top