rearranging seat and table in 2008 22'

B

BaseCampAnne

New member
I do not know how to change out the direction of the seat and lower the table, if that is what I would do to make sleeping space. As far as I can see there are little holes in the bottom fiberglass to secure the seat but I have been unable to connect with them when they are not visible.

Suggestions?
Thanks,
 
Open the cabinet door on the forward seat there are 2 drop in pins. Lift the pins and slide the seat up against the forward bulkhead. There is a spare cushion that snaps on to the forward bulkhead. The cushion on the table back gets stowed. There is a post about 12 inches long that replaces the long one that holds the table up. Remove the table top by sliding it forward on the hinges. The table rest on the teak on the rear seat and on the front seat. I have to slide the cutting board out a little on mine and rest it on the front seat teak.
 
Hi C-Brats, Following on Jody's remark about the removable cushion attached to the table-leaf, I was interested by the seat back that appears in C-Breeze's modification album (look at new album additions on left side of home page.) C-Breeze, if you are not out cruising, where did you find the seat-back that you have dropped into the table mounts? That sure looks like a better solution for seat upgrades, rather than strapping a fat cushion to the table-leaf. I don't find that arrangement to be very good; table-leaf and cushion just flop around unanchored.
Thanks, Rod
 
Back
Top