Radar Removal

T

Tug

New member
I just removed the monitor and monitor bracket for my old radar. To remove the Radar dome do i just cut the cable as short as possible/remove the four ( 4 ) . bolts that secure the dome to the cabin roof and pull.Is there anything else beside sealant holding the dome down. Tug
 
Cutting the cables trashes the radar, which is OK. Another approach is to remove the radome, disconnect the cable from the inside and feed it back through the hole in the (I assume) cabin top.

Either way will work, just depends on the purpose.

Boris
 
Tug-

I don't know how far north Issac will get before it dissipates after landfall, but you might want to plug that hole if you think it's gonna' rain!

Joe. :teeth :thup
 
Sea Wolf":285w5bsn said:
Tug-

I don't know how far north Issac will get before it dissipates after landfall, but you might want to plug that hole if you think it's gonna' rain!

Joe. :teeth :thup
Click to expand...

:thup :thup Duck tape!

Hope the Midwest gets some of that rain!

Charlie
 
I did just that...i removed the Radome and disconnect all those little snap connections and feed the cable thru the hole in the roof.When i removed the Radome i was surprise how clean and new it looked..really sparkled.Tommorrow i will seal the holes with West System Epoxy, remove the wiring from the boat and store it in the basement with everything else. It's probably an easy fix if some-one wanted to buy it but i don't know how you would go about shipping something this big. Tug
 
Charlie..thanks for the tip...i went out and measured. The Si-Tex holes are approx..210 mm and from the Furuno 1715 on-line operators manual the new holes are approx. 160 mm. Tug
 
Had to cut the 10 meter cable...the wiring and electronics must of been installed when the boat was new...The cable was so interwound with the other wiring i was afraid that i would damage the existing wiring.
Good idea ..i will advertise it on Ebay.. Tug
 
Tug":1osanfhi said:
Charlie..thanks for the tip...i went out and measured. The Si-Tex holes are approx..210 mm and from the Furuno 1715 on-line operators manual the new holes are approx. 160 mm. Tug
Click to expand...

WOW 210 mm is over 8" hole :shock:
 
BrentB":ghwqij22 said:
Tug":ghwqij22 said:
Charlie..thanks for the tip...i went out and measured. The Si-Tex holes are approx..210 mm and from the Furuno 1715 on-line operators manual the new holes are approx. 160 mm. Tug
Click to expand...

WOW 210 mm is over 8" hole :shock:
Click to expand...

Probably means hole pattern, right? 160mm square vs 210mm square.
 
Back
Top