leaking tilt on 2011 Honda 30hp

R

Ron Cowan

New member
My 2011 Honda 30hp on my log puller tilt is leaking down in about 4 days. The engine has about 250 hours and there is no hydraulic fluid showing around a leak. I assume there must be a seal that is leaking by in the cylinder. Has anyone had this issue and is it a repair to tackle?
 
Ron Cowan":1hv8nmd3 said:
My 2011 Honda 30hp on my log puller tilt is leaking down in about 4 days. The engine has about 250 hours and there is no hydraulic fluid showing around a leak. I assume there must be a seal that is leaking by in the cylinder. Has anyone had this issue and is it a repair to tackle?
Click to expand...

There is a bypass screw on the left side of the pump(for lowering if no elect. power) make sure that is tight.
Some times a ck valve (internal) will get a piece of debris in it & not seal well. I would get the book out, drain all the oil out into a clean container & look for paint flakes or something that is not clean hyd oil. Refill with clean oil as per the manual. run it up & down a bunch & repeat, see if that wont cure it/flush it out.

Have a good one :wink:
 
Ron Cowan":19rkaa7c said:
My 2011 Honda 30hp on my log puller tilt is leaking down in about 4 days. The engine has about 250 hours and there is no hydraulic fluid showing around a leak. I assume there must be a seal that is leaking by in the cylinder. Has anyone had this issue and is it a repair to tackle?
Click to expand...

I’ve never heard of a “log puller tilt”, is it a particular style of tilt mechanism?
 
Sorry for the poor wording in my post. The tilt is the engine tilt on the engine on a modified pontoon used for pulling logs out of our subdivision waterways.
 
Ron Cowan":icwubu24 said:
Sorry for the poor wording in my post. The tilt is the engine tilt on the engine on a modified pontoon used for pulling logs out of our subdivision waterways.
Click to expand...

Ron, no worries! Sounds like you have quit an operation! Thanks!
 
Back
Top