Cabinet hinges

[katkt]

I'm looking for a source for corrosion resistant concealed cabinet hinges.

I'm reworking the lid to the storage area, in the cockpit of my TC24. I'm raising the seat area to make room for storing an eu2000 inside.
The factory screwed a regular hinge on top of the lid, and screwed it to the fiberglass behind the seat. By raising the seat, I'll pick up 2" of room underneath and conveneintly cover the old holes.

What I'd like is a hinge, typical of Blum or Grass style concealed cabinet hinges, that can be mounted to the underside of the lid, and the inside of the raised seat frame.
Does anyone know a source for stainless in this style of hinge? Or, has anyone used the regular hinges, and found that they resist corrosion well enough for marine applications?
Worst case.............which certainly wouldn't break the bank.........would be to use a regular cabinet hinge, spray it with corrosion X and replace it every year.

Thanks for any help.

Gordon

PS forgive me for putting this in the wrong category.

 

[thataway]

Gordon
Kitchen Cabinet Hardware.com has SS Euro hinges:

http://www.kitchencabinethardware.com/e ... ories.html

We had considered just using a pin type of motor box hinge (full opening) if we had raised the box lip on the TC 255 (not sure how similar the aft boxes on the two boats are)

 

[SEA3PO]

You can look at all the Perko brand of marine hardware on line..... most marine stores only carry a small fraction of the stuff they have available...and you can special order any from most local marine stores..

Joel
SEA3PO

 

[katkt]

Thanks for the link Bob.
The aft boxes are pretty similar. When I was looking at yours last year, we talked about the Genny being to tall to sit in the aft compartment on yours. Mine was 15 inches and I needed 17.
I came across some Spanish Cedar at an irresistable price, and I'm using that for the deck surface around the lid. It'll have an apron of the same around the front to hide the blocking used for raising the seat.
The lid is rabbited into the top enough to allow for some sort of weather seal under the lid. The Euro style hinges with the quick release tab will work great if I can find them.

Thanks for the Perko info Joel. I'm being alittle lazy by not searching these out for myself. The C-brats are always doing something to their boats, and I figured if there was anything out there somebody here would know.

I'll post some pics of the deck, and a slat floor that I made for the floor of the head(to dress it up), in a day or two.

Thanks again gentlemen

Gordon