Search results

Backing to support inner skin and screw new core down to sandwich core to skin

Applying epoxy

New plywood core in

Fairing around new core

Glassed and faired

A35A1749-2A90-448F-AC25-8A824C4E8344

Rolled on gel coat. Maybe try to match slip stop some day. Or grind it all off?? For now it?s solid and dry

Planning the repair and outer skin removal

Removing the skin and core. A job for a good friend. Or perhaps a job only a good friend would do.

Rotten around hawse hole

Rotten around unsealed windless

Ready for new core

I have my fuel tanks out in 2004 22 cruiser. Fixing the rot where the screws went into the hull. Was thinking about epoxy glassing some cribbing around the tanks and the running the strap down to the hull. This would eliminate the board between the tanks and the cockpit. Is this ok? Or is...

Thanks. Ya I have been drilling and using the Allen wrench in a dill method to get any rot out. Then drilling bigger or another hole if I can’t reach solid wood.

The boat is on the water fully exposed to the sun so the temperature is always changing it’s been as hot as 90 and this morning was in the high 30s. Mixing smaller batches in 10oz cups using popsicle sticks to mix and apply. 5 pumps with the mini pump set is the most I have done. Using a hole...

Thanks Daybreak, Right now I’m just trying to figure out how to get consistent results with epoxy. I have the port tank removed and all the penetrations into the core drilled out. Some holes are up to 2” hole saw. I seam to be getting a lot of bubbles when the epoxy goes off. Using west systems...

Hello! My name is Connor. I’m about 2 months into being a not too proud 22 cruiser owner. Really like the boat and how it functions for the family and I. Just disappointed in the condition of the particular boat I bought. Which is 100% my own fault. Anyways I just wanted to say hello and...