Search results

I pushed a little too hard when closing a sticky side window and the latch unit came off. Anybody know what glue/ adhesive is used on this part? Thanks.

2008 19' Angler with 2007 Honda 90 FI motor and Venture single axle trailer. Includes: Swim platform w/ ladder, drop curtain, grab rails in cabin, Lowrance LMS 520c depth/ GPS, porta potti (new), permatrim, Bennett trim tabs, Angola full boat/ motor cover, Dickinson propane heater/ fireplace...

There are two cracks in the gray cockpit floor covering in my 2008 19' Angler, as if the covering is peeling up. They don't go down into the fiberglass...you can slip a knife blade on the flat under the flooring. They are approx. 12 to 18" long. Any suggestions?

I recently bought the overpriced C-Dory factory cooler rack that doesn't fit my boat despite what the factory said....it's too short. After cleaning the goop off with solvent, I proceeded to devise a "make fit" solution. My question is...what's the best cooler for this rack...I've searched the...

I need some advice on the best way to fasten a ski tow line to my 2008 19' Angler. There are two screw (bolt) eyes on the transom. Are they strong enough?

My Honda 90 is mounted on the transom in the second hole down from the top and I have read that the Permatrim should not have water flowing over the top...mine does. Where have you other 19' Angler positioned your motors?

Well, after 2 years of lurking, I signed the papers today on a new, '08 19' Angler, 90HP Honda, with John at Sail Annapolis. It will be a trip to go get it, but not too many 19's around to pick from. I would have gone for the 22' Angler but it won't fit in my storage building. Can't wait for the...