Search results

Transom should be plywood (still don't want it wet) I epoxied mine back down last fall on port 2'. on another note, is the LPOIC still active, any Big Kams still being caught?

I put a Planar 44D-12 under the helm seat(ice box)ran exh. through the cabinet wall and exits the hull in line with the sink drain approx. 8" below the rub rail. I also wrap any exposed exh. pipe with fiberglass headder wrap & stainless monel wire. some picts in the TMR-TOO folder of a hews...

Re: WHEN DO WE RETIRE FROM BOATING? The day your ashes are spread on the SEA!

(I know that is "mild summer weather" for some of you.) Smart to stay at home / inside, even here people can't drive in SNOW! :roll: :mrgreen: :thup

:lol: :lol: :thup YUP! Rules are for THEE not for ME! :roll:

Check into a FREIGHT FORWARDER? Ship to forwarder in seattle area then barge it to the port! Pretty reasonable. Gear shed in Homer does/did this in the past! Give them a call? :thup

Sea Bass (black rockfish) Hot Skillet, butter, salt, pepper & GARLIC!!!! :thup :thup :wink:

Fuel / water separator with extra filters on board.

The C-dory sky will FALL!

I have 2 G31 deep cycles (parallel) for the bilge pump/house, I have 2 G 24 automotive start batt's (parallel) for starting, all lead acid. I replaced them all after 11 years. Not bad for OLD SCHOOL!

You can get anything shipped to AK with your friendly freight forwarder, :thup usually cheaper than you think! Call the gear shed in Homer they will know who to set you up with.

:thup :thup :thup

25" shaft for the 25 and witch ever the closest dealer is! I personally will buy Suzuki again after owning all of the above! :mrgreen: :thup :thup

Only with breaks on the trailer! It ain't always the pull, you have to stop sometimes on SHORT notice. :wink: :thup

On my HEAVY LOADED 25' with 175 Suzuki, 2 mpg is the average. At 3500 - 4000 rpm I can get 3-4 mpg at 6-8 knots but if the water is decent, I can't go that slow!

Is the Tach. setting correct? (cylinder# selector S/W on the back of tachometers)

:wink: :beer :mrgreen:

I believe mine is 6'4" Long and approx. 36" wide. Need exact your SOL here :thup :thup :mrgreen:

It should be on the bracket that bolts the engine to the transom. Wright it down / take a picture, call any HONDA DEALER THEY CAN TELL YOU WHAT YEAR! :thup :thup

Serial# is how the dealer defines the year of production! Year doesn't matter SERIAL # DOES :thup :thup