Search results

004 (2)

005 (2)

006 (4)

007 (4)

010 (4)

011 (4)

012 (4)

001 (2)

I found the following information on launching from MDR. I haven't launched from there before but might be up to it to meet people for dinner and have a new experience. :?: Can anybody verify this information that has launched there before...

I have a Bruce (Lewmar) knock off but it resides in the support vehicle for that chance to go to PNW. Down here in So. Cal, a real Danforth or better yet a Fortress or Guardian is my favorite...works great in the Gulf too. The Bruce is my opionion is too heavy and doesn't work as well as the...

I think I've seen one C-brat boat with an out board bracket like this one. Does anybody have any experience knowledge or thoughts on adding one to a CD22? Aparently they would space my twins back from the transome and have positive flotation. Several manufactures make them and I've seen Skagits...

TWIN

WARNING! We just got back from a trip to the Gulf. My wife liked it so much the boat, trailer and tow vehicle stayed! We flew home to So Cal. We're going back in May for more boaterhoming. . We'll be exploring more of the west coast of Florida throughout the spring and maybe more in the fall...

I emailed <jtuson@olypanel.com>the factory rep for Olypanel the factory that makes decraguard and ask her where I could get some. The factory rep refered me to a local plywood wholesaler. He in turn contacted the decraguard rep and the only thing they could offer me was a nine 4 X 8's that were...

I have a friend who has an old navy issue flare gun. It's 12 guage with a long barrell. Some of the "flares" he was caring in his emergengy kit didn't appear to be of the signaling variety.

I'm assuming that your observed motor position doesn't jive with what your meter is reading? The Honda manual says if there is a problem to change the sensor. The picture in the trim/tilt supplement for my BF50 shows that the trim angle sensor has a connector that should pull apart...so its...

Checked mine again today. Found that the plastic arm was bending and slipping out of place. It's supposed to apply pressure upwards. I observed it slip in front of the transmision casting instead of staying behind. Some marine lube (grease) on the points of cantact helped. Further lubrication...

About 2 hours later the install is complete.

Per instructions these burrs have to be cleaned up