Search results

I wanted to get a few CBrat recommendations on good install locations for a BMV-702 display before I drill a dash hole. Don't want any regrets after the hole is drilled :shock: Does this look like a good spot? http://www.c-brats.com/modules.php?set_ ... _photo.php Second question: I am...

BMV-702

Pole Mount

Thank you Bob! What gauge wire would you recommend running between the ACR, switch and battery terminals? I went with the 'bigger is better' mentality and chose 2 AWG, but it's large and cumbersome. Smaller AWG would be more flexible and easier to run. I have 2 yamaha 50s, not sure if that...

The leads coming out of the ACR in the diagram above have an s drawn in the line with little circles. What does this symbol represent? Is this where a fuse is installed? I've installed 80amp fuses where the s appears on the blue sea install. I believe this is one of my problems. Same s...

I am following the Blue Sea diagram for my installation which may not the best way to go. The diagram calls for 80 amp fuses between the relay and switch, not sure why. Would certainly be an easier and cleaner install without the fuses. I’m afraid of deviating from the instructions, but you...

After the new Windlass was installed, it became apparent that my existing battery setup was not up to snuff, so I am in the process installing new batteries, blue sea relay and switch, waterproof charger and BMV 702. It's a tight squeeze but everything fits and is secure. I am a newbie so any...

Electrical 8

Electrical 7

Electrical 1

Electrical 6

Electrical 2

Electrical 3

Electrical 4

Thank you Sunbeam and Thataway. Just ordered Butyl tape from the sitelink provided and that amount should last several years! :thup

I've used Silicon for several boat projects and its a real bear to clean up. Not to mention that after a year of being in the sun, the silicon turns yellow. I just ordered DAP Butyl from Amazon and will start using that instead. What cleaning solution would you recommend using to remove...

Thank you Bob. Should I use 3M 5200 to seal the bilge exit fitting or marine silicon? I worry about using the 5200 because it's permanent and I wouldn't be able to remove the fitting if there was ever a problem.