Search results

I found a bimini top for a 22 that is for sale after the boat was damaged in a storm. They guy wanted $150.00 for the top, which is reasonable, but he said the shipping would be another $150.00 from FLA to VA. I was wondering if anyone had experience shipping a bimini for a more reasonable...

Even though it appears to be a good deal get a survey. I bought my 2005 boat from an 84 year old guy who always kept the boat covered. I figured survey wasn't needed, particularly since I got a good deal. However when the boat was washed etc, water accumulated under the tank and rotted out part...

1467293 780182855333360 1528191313 n

10170884 780182612000051 1928184860 n

100 0509

100 0508

Appreciate the comments. Sounds like pulling the fuel fill would be a good idea to check the core there anyway. Anyone know the thickness of balsa in the deck? I should have measured, but it was at least and inch thick. I cut an inspection hole where there was water coming up through a screw...

Any advice or tips on how to get the fuel filler hose off the gas tank. I need to remove the tanks to replace the deck. I figured I would remove the tanks, over drill and epoxy the holes to prevent deck rot on my 2005 CD22 as recommended in numerous threads. I bought the boat three months...

100 0511

Seems that my max rpm is on the low side. I'll have to check the pitch on the prop next time I get to the boat. The boat is light and at sea level. Thanks for the replies.

I have a C-dory 22 with a carbed honda 90 and can get 5200 max rpm on flat water with the outboard trimmed up half way. Does that sound like the appropriate max rpm for my boat/engine combo. Thanks, Dan McPartlin

Where along the loop does the trip start? I would be coming up the James River.

Pay close attention to the rear hatches. Unless the owner epoxied the edges of the cut-out OR kept the boat completely dry, the core will be wet there. T

I would love to do this trip!

To Sobelle, Here is a link to a discussion board that has a copy of the manual for changing a honda 90 impeller in one of the posts. I couldn't figure out how to copy and paste the attachment into this forum. http://www.marineengine.com/boat-forum/ ... eplacement. Appreciate everyone's...

Changing the impeller on my new boat next weekend. It has a 2005 Honda 90. I was wondering if you have to drain the lower unit oil before dropping the lower unit? I have the diagram and instructions for replacement, but there is no mention about draining the oil. Thanks, Dan McPartlin

I would suggest staying at Coinjock marina on the intracoastal waterway portion, Elizabeth city public marina prior to entering the dismal swamp. If you are looking at the docks from the water, there are smaller berths to the right that you be better to tie up a c-dory. If you wanted to make it...

Recently purchased a 2005 22 with a windlass. There are few dings at the bow where the tip of the anchor sits on the roller. Was wondering what folks use to protect the hull just below the rub rail. There are scuff plates etc online, but not sure if they would work since the hull is angled in...