Search results

Jim I agree about keeping the boat in the water - I just won't leave it for 3 months without "safe hull". I'm a traveler to the ocean and can only swing 2 weeks at a time. H

HI FOLKS Finally have the barnacles removed - had to sand the bottom to get the little circles. Finished with 200 W/D so the surface is pretty smooth. The finish is glazed white from the sanding. I'm trying to decide between adding bottom paint of some kind or trying to refinish the gel...

I have a CC23 with a Honda 135 and am happy with the performance - runs great good mileage H

Hello Brats The Kicker with a 20" shaft I bought on E-bay turns out to be a 25". It looks like the Prop Cavitation plate will end up a few (3) inches below the bottom of the boat. Can the brackets which raise and lower kickers be used in the up position to get the motor up a little or is there...

Hi Folks Removed my port swim platform to mount my kicker. In the process it pulled a credit card piece of the surface off - Obviously needs to be repaired. Have pictures but couldn't figure how to get them up. Does someone make a repair kit? Also I scratched the side on something...

Hello Again Got my 9.9 Honda Kicker. Will not fit over my transom. Can I remove the bolt and screw it to the transom? It was described as a 20" shaft but it seems to sit a little low - might be a 25". I can build up a mount which will raise the motor and allow for mounting. Any Photos of...

Hi Guys & Gals My barnical removal will end with me sanding with 400 emory to get the little circles off. What next? Can I repaint like the factory does? Or am I looking at bottom paint any suggerstions?? Specific products? Thanks Hank

DUH That is the valve I have with one position plugged. Easy Hank

Got it - keep worring that I will reverse them I was referring to starboard. One more Q Is there a reasonable way to connect the kicker to the fuel supply line as well as a tank (not at the same time) Thanks H

Hello My kicker will be here tomorrow and I assume I will need to pull one of the swim platforms. I"m thinking about mounting to the right of the engine because of all the cables & lines there - leaving the left for back access and entrance. Any advice or warnings? Thanks Hank

Just the inline fuse in the back??? H

I have not done my homework - is the small honda generator a 1 hp or 1 kw?? I'd like someting to run the charger and to run a vey small ac for a couple of hours on hot days. Any roof mount units available. Thanks hANK

Hello folks \ Looking to get a 1 hp Honda generator for reundacy etc. Can this unit run a tiny AC unit - have a CC23 so the space is small - like to mount on the roof if possible. Looking to cool for a couple of hours at the end of a hot day. Any Ideas?? Thanks Hank

Thanks That helps and makes sense I bought the boat used but will call the dealer - they should know Hank

recommendations for a specific paint - My boat lives on a trailer and will be in salt water 4-5 times a year - longest trip would be about 10 days I just finished removing a full barnacle beard having left the boat for 10 weeks in Wilmington \ the surface is scratched from the scraping so I...

Hello again I'm putting a Honda 9.9 kicker on my CC 23. How does one determine the shaft length? My 135 measures about 26 inches from the transome to the center of the prop. Would that put me in the 25" shaft or are the Kickers higher up than the regular motor. Any comments about the...

Thanks Eric Have the NC & SC deales and will sart a CallaThon H

2006 CAPE CRUISER 23 • 2006 23 Cape Cruiser (like the Venture) • 2006 135 Honda EFI • 229 hours • 2006 Magic Tilt Trailer • Dual Batteries w/ switch & Charger - Inverter • Twin swim platforms • Lenco Trim Tabs • Bimini Top w/ full camper canvas • Snap on screens • Navman...

Long drive to CA - I have the NC & SC dealers nyumbers and will call today. Any consumer reviews on the honda 9.9? (differences in year models) I just read the thread on the 5 hp Kicker? I choose the Honda because I like matched things even though others weigh less and cost less. How do you...

Hi Folks I'm looking for a Kicker for my CC 23 - have you seen any of these at your local dealers?? Please let me know Thanks Hank