Recent content by UncleRichie

C-Critter

Hi I have a Honda 8 horse out board it runs very good but something has rotted out in the cooling system have replaced the impeller and such was wondering if anyone on here would like it its free though I would put it here first its a 2000 model and the two likely things that are bad I can't...

If you you just need to get them working again for a while take them and make a little tray out of aluminum foil and soak them in alcohol over night this will soffen the rubber up again and they will work for a while more. It does the same thing as what you put in a leaking auto trans to make it...

stainless work hardens if you don't work the brakes to bad for the first few miles the rotors will get a hard surface and then not wear much after that I have them on my trailer and like them its the calipers that is a problem for me wish I had just bit the bullet and bought the stainless ones...

Thanks will try and see if it gets more water in it changed the oil but have not changed the thermostat for a while . Richard

I have a honda 8 hp made in 2000 I just checked it and have water in the oil anyone have any ideas where it could be coming from . I have alwise flushed it after each use in the salt ,it runs fine no smoke or water vapor coming out the exaust . Anyone have any ideas have looked on line and not...

Am going to take the heater out this week and see if i can rebuild it or get it working again will post results when done. Richard

Have checked fittings it is not pumping fuel at all though maybe a check valve stuck though maybe I could rebuild it . I have not pulled it out yet though I would ask here if anyone else has done a rebuild on one or if it is possible. Richard

Have trouble with my wallas stove will not fire up ,I did not start it for several months the fuel pump runs but never seems to pick up any fuel . Has anyone worked on the fuel pump it is easy to get to but I don't no if it is rebuildable or a non serviceable part anyone done this ? Richard

Thanks for all the replies will try some of what you say . Richard

I have a wallis heater and it will not start up I can hear the pump running but it does not seem to pick up any diesel Is there a way to force a little bit of diesel up to it ,it has been setting for a while . I have been starting it on and off but this time I let it set longer then normal ...

If you have trouble with epox use 3m stuff I have used 5200 and it will flex some and is very strong a friend used it to mount the block for his crab pot puller worked great , I put some hangers up in the cabin and had to change it took me over a hour to to get the thing off had to use a...

Hi have you ever used the cut off discs from a cut of air tool When they get down two about 2 inches you can''t use them any more ,was thinking about making a holder for the dremel to use the rest plus they would last a lot longer then the dremel discs. They have a 3/8 hole in them so would...

I have the 22 with the 75 honda carb model if I had to decide now I would go for the 90 horse not sure what brand , I was lucky my 75 is a very good motor will run almost as good as a 90 . You can always use a little extra horse power never know when that will help . The 70 or the 90 will get...

Check out C-Critter pictures mine is only for three poles but could do more then one, one end is split and hinges down. 3M 5200 holds it in place very solid. Richard