Recent content by moonular

Thank you for that answer, The seat boxes are fiber glassed into the 'inner' deck and inner side hull. Still not sure if an inspection plate access is advisable in the side of the cockpit area. Has anyone done this? Seems like it would be OK and that ALL i WOULD NEED TO DO IS REMOVE SOME FOAM...

Hello, I hauled our 2006 Angler 19 for bottom paint and water continuously drained very slowly from a tiny hole under the helm station seat box where the fiberglass seat box meets the deck. There is NO visible leaking from any above waterline fasteners. I'm wondering if the rivets for the rub...

Hello, I have an old Garmin 192C Chartplotter and am looking for a chart card for the west coast of Canada. It takes the older Blue Chart Americas style map cards. Anyone willing to sell one? Thanks!

Hi everyone, I just wanted to share with you all my installation of 2 Sunwize 24w solar panels. Each one has a dedicated Morningstar controller and each one feeds a separate group 27 battery. The trick "SS" clamps I used to attatch the panels onto the existing handrails were from Gemini and...

Awesome Jim! Thanks for that flashlight-I could do it tomorrow during daylight- effort. The C-Brats, nuthin' like um'.

Hi there, anybody know the distance between the cabin top hand rails on an Angler 19? (not center to center - the inside edge to the inside edge). Thanks for your help!!

The only thing you should have going to your batteries are the bilge pump wires (fused within 6" of battery), the battery charger cables if one is installed (also fused within 6" of battery). And the main DC Panel Pos & Neg cables of appropriate size (depends on the total load (all electronics)...

Thank you for the info! I will be using these slick "Split Jaw Mounts" from Gemini to attach my solar panel (bullet proof SC24w from Sunwize) to the cabin top hand rail. They provide for a "standoff" so you can still grab the handrails. http://www.geminiproducts.net/gemini-side-mounts/ PS I...

Hi there, simple question here. i need to set up a solar panel rack system for my 2004 Angler 19 and I need to know the rail diameter of the cabin top hand rails. Ya, sounds strange but the boat is stored quite a long ways away and i want to take the parts with me to the boat. Can anyone tell me...

I have a 2004 Angler 19 and want to upgrade the bilge pump system. The factory installed "on-demand" pump back between the fuel tanks will do nothing but drain my battery (periodically turns on by itself to "check" for water). Two problems; 1. There is no recess in the deck to set a bilge...