Prev
initial photo after the \"flapper\" valve is taken off. There is gel coat smeared over the wood boring, and some voids.
Next
Prev
a layer of glass fibers and a layer of 10 oz cloth laid over the void with epoxy. A second layer of cloth is placed over this and into the transom opening
Void from the inside, cleaned out for glass application
Wood sanded clean--notice a small void at the very back, where the aft deck is attatched
initial photo after the \"flapper\" valve is taken off. There is gel coat smeared over the wood boring, and some voids.
Foreward part of hatch plywood, with spray of gel coat over the raw edge
Two trim screw holes where water was comming thru the deck from hatch lack of bedding
Moisture on plwywood both from screw holes and from around the lack of caulking
Next
T

initial photo after the \"flapper\" valve is taken off. There is gel coat smeared over the wood boring, and some voids.

  • Media owner thataway
  • Date added
initial photo after the \"flapper\" valve is taken off. There is gel coat smeared over the wood boring, and some voids.
Click to expand...
There are no comments to display.

Media information

Category
Thataway
Album
In driveway
Added by
thataway
Date added
View count
2
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top