Search results

I looked at the photos from Joe posted. Quite a project and it turned out very nice. I am looking at a couple of fiberglass sheeting manufacturers that make a single piece large enough to span the entire bulkhead. I have not quite nailed down a sheet that has the finish I'd like. I am also...

Does anyone have access to info, line drawings, for the rear bulkhead for a 22 Angler. I notice that most of the more mature models came with what appeared to be a wood rear bulkhead with standard windows and door. I'm considering fabricating one from a fiberglass sheet material and having the...

1/2 inch stainless bolts - 4 inch top and 3 inch bottom with stainless washers inside and outside, stainless nylock nuts and stainless fender washers inside transom under standard washers. All SAE 2 course thread.

Tab controller

Just a nice day on the lake

What better view than that?

Looking through starboard lazarette hatch

Tab pump and control module in starboard lazarette

Tab pump, control module, hoses, wiring

side

back

front

Okay. At the advice of Boris - and due to the guilt at putting lesser quality hardware on my C-Dory - I went somewhere besides the big box hardware stores and purchased stainless steel bolts, nuts, and washers to attach the Mini Jacker. Still don't know what they should be torqued to but I...

Charlie, I actually already bolted the plate on and did exactly what you suggested on the snugging. I just didn't want to leave the bolts under or over tightened. I did do the over drilling, ground out about 3/16 core and epoxied according to Bob Austin and West System's recommendations...

I am installing a Mini Jacker jack plate and am wondering if anyone knows what the 1/2 inch thru hull bolts should be torqued to. The torque charts for grade 2 galvanized bolts with 13 threads per inch is 39 foot pounds but I am unsure if that is too much torque for the transom. Any info would...

Instant shade from Sam's Club

starboard inside - close call with tank tie down