Recent content by Yukoner

My old 22 Angler sandwiched between Water Buoy (a newer 22 Cruiser) and Kismet (formerly Great Republic, the redone 26) 1982 22' Classic Repower .... looking for feedback. Coles notes: is 500 lbs too much to hang off of the transom, either as a 90 or 115 and 9.9 combo? Am I going to notice...

Progress. New keel strips done in oak. I radiused the edges with a router, drilled, countersunk and finally sanded. The new strips are bedded in thickened epoxy and clamped to the hull with stainless fasteners. The fastener heads have been covered with epoxy and the edges have fillets. Next...

I hear you. I am using cloth - it's a biaxial cloth of some sort. Can't remember the weight. I'm hardly a fiberglass guy and I interchanged the terms on account of my ignorance. I sourced my epoxy supplies and cloth from Edmonton Boatcraft. Took the time and went through with the proprietor to...

To remove it from the trailer was easy. I milled some 6/4 lumber, cut it into cribbing and then positioned the trailer tongue down. I installed cribbing at the stern and then raised the trailer jack. This put the rear of the boat onto the cribbing. I then used a floor jack and more cribbing at...

Quick question on the Taco rub rail inserts. They are the 1" tall x 1/2" wide model, correct? Taco part number V12-0303? Both my port and starboard inserts need replacement. My current ones measure out just a hair shy of those dimensions, but they are also assumed to be 40+ years old. Also fun...

I appreciate the feedback. To my knowledge the core is good. I see no cracking or heaving which would likely show up while she sits at -45 in the winter. The boat is older than I am, so I am unsure as to what was factory and what has been modified. Understandably she has gone through a few...

Hey there, I purchased a 1982 22' Angler off of my cousin a few years ago. What a great, cool boat! She has 3 wooden strips on its hull - 1 center 'keel' strip and 1 roughly under each gunwale. The starboard side strip has been broken off forward of the cabin bulkhead long since before my...