Prev
This is the limit of my forward cut and I\'m having the same problem/question. You can see from the shadows that it is very uneven
Next
Prev
Fiberglass laid on the floor!
Most of the balsa cut to fit.
This is where I removed the v-berth bunk and will have to replace it someday. Do I grind everything back at a 12:1 ratio to prepare for that?
This is the limit of my forward cut and I\'m having the same problem/question. You can see from the shadows that it is very uneven
Along the sidewall I ran into filler where the balsa core met the wall. You can see a lot of air pockets and thick epoxy. How smooth does this need to get?
This shows the various ways the floor looks: nice pink smooth fiberglass, icky black fiberglass, areas of fuzzy mat and a lot of unevenness. How much sanding do I need to do to get it ready for new mat?
The dotted line is where I left off. I had one little black line to follow back and thought the rest looked pretty good. Once I cut in it was full of water back there. The smooth areas are where the balsa was not adhered to the floor at all.
Next
J

This is the limit of my forward cut and I\'m having the same problem/question. You can see from the shadows that it is very uneven

  • Media owner Jackie
  • Date added
This is the limit of my forward cut and I\'m having the same problem/question. You can see from the shadows that it is very uneven
Click to expand...
There are no comments to display.

Media information

Category
Balsa core rot. (Liquification)
Album
First cutout. It was clearly hollow under here.
Added by
Jackie
Date added
View count
2
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top