Prev
Side view of cut out piece, which was sanded to fit the frame. Then I drilled a large finger hole in the center.
Next
Prev
20171004 144820
Finished product
Side view of cut out piece, which was sanded to fit the frame. Then I drilled a large finger hole in the center.
Finished frame on starboard side.
Finished frame in place on port side.
Cut out on starboard side of V berth.
One of two cutouts under the V berth cushions. I traced around the frame, and cut it out with a jig saw, using a metal cutting blade.
Next
D

Side view of cut out piece, which was sanded to fit the frame. Then I drilled a large finger hole in the center.

  • Media owner dpod2003
  • Date added
Side view of cut out piece, which was sanded to fit the frame. Then I drilled a large finger hole in the center.
Click to expand...
There are no comments to display.

Media information

Category
New V berth access hatches
Album
Shows the two frames purchased from the C Dory factory here in Bellingham, and the two cut outs I made.
Added by
dpod2003
Date added
View count
2
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top