Prev
second one by the rear of cabin,laid a bead of marine silicone on the bottom of deck plate flange to seal used 10/32 stainless screws with nylon lock nuts to hold in in place
Next
Prev
The old version of cards we used to hand out to people interested in the C-Dory line of boats.We should have added the website address,but they can get through the c-Brat website which is listed
inspection hole with deck plate at the rear of the cabin
Cut three six inch inspection holes,used deck plate cover flipped upside down went around it with a sharpie. Used two inch hole saw finished off with a jig saw. Make sure your placement allows room for jig saw to make the cut.
second one by the rear of cabin,laid a bead of marine silicone on the bottom of deck plate flange to seal used 10/32 stainless screws with nylon lock nuts to hold in in place
cockpit deck plate and picture shows removed starboard side fuel tank, Removed pickup checked for anti siphon valves removed screens cut pickup tubes on a 45 degree angle.I had shoveled a 1/4 drive rachet in the fuel pickup line to keep any crawling critters out.
the second rubber strip the tank was sitting on had slid out a while ago reinstalled with contact cement. The front one (shown) stayed in place.
An 2008 Venture 30 gallon aluminum fuel tank. The second rubber strip it sits on laying on top, contact cement drying. No anti siphon valves found on my fuel pickups
Next
W

second one by the rear of cabin,laid a bead of marine silicone on the bottom of deck plate flange to seal used 10/32 stainless screws with nylon lock nuts to hold in in place

  • Media owner Will-C
  • Date added
second one by the rear of cabin,laid a bead of marine silicone on the bottom of deck plate flange to seal used 10/32 stainless screws with nylon lock nuts to hold in in place
Click to expand...
There are no comments to display.

Media information

Category
Will-C
Album
IMG 2405
Added by
Will-C
Date added
View count
2
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top