Prev
On the Erie Canal I had caulked the parameter hoping it would tide us over until I could pull it but it didn't and I can see why
Next
Prev
Another boater lent me this great little pull scraper to clean up the parameter.
I think the reason it never sealed correctly (I'm guessing from the factory ) is that the machine screws that hold the hinges stick out about 1/32 -1/16. When the hatch was tightened down the screws left a mark on the gel coat and stopped the hatch from fully compressing the caulk right underneath the hinges.
first: clean up all the old caulk and muck
On the Erie Canal I had caulked the parameter hoping it would tide us over until I could pull it but it didn't and I can see why
the leaks came from under the hinges where the caulk had not quite spread out all the way to create a seal
The main hatch has has been leaking for a while but I wanted to get off the great lakes before taking it apart (I made a quick and dirty rain cover that attached into the four existing snaps for the sun shade)
Next
S

On the Erie Canal I had caulked the parameter hoping it would tide us over until I could pull it but it didn't and I can see why

  • Media owner sebastien
  • Date added
On the Erie Canal I had caulked the parameter hoping it would tide us over until I could pull it but it didn't and I can see why
Click to expand...
There are no comments to display.

Media information

Category
Front hatch repair
Album
The main hatch has has been leaking for a while but I wanted to get off the great lakes before taking it apart (I made a quick and dirty rain cover that attached into the four existing snaps for the sun shade)
Added by
sebastien
Date added
View count
1
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top