Prev
Notice the three holes where the bilge pump was mounted. Another potential water leak into the balsa core.
Next
Prev
Spent most of the winter drying out the core with a heat gun shooting into the holes when I had spare time.
Cut into the lower area where water collects for the bilge pump and drain plug area so no puddles will form around the transponder mounting.
Notice the three holes where the bilge pump was mounted. Another potential water leak into the balsa core.
Marking the spot where the transponder base will be mounted.
Had water intrusion into the balsa core where the gas tank brackets were screwed in so I drilled those areas out with a hole saw.
4 inch hole saw to begin the installation. Wanted it mounted as far aft as possible.
Next
C

Notice the three holes where the bilge pump was mounted. Another potential water leak into the balsa core.

Notice the three holes where the bilge pump was mounted. Another potential water leak into the balsa core.
Click to expand...
There are no comments to display.

Media information

Category
Shoot Through The Hull Transducer Installation
Album
4 inch hole saw to begin the installation. Wanted it mounted as far aft as possible.
Added by
CaptainJeff
Date added
View count
3
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top