Making a set of "usable mock-up from scrap" cover boards for the sink and former-Wallas hole in the galley counter. Two sheets of scrap 1/8" ply epoxied together to make 1/4", then cut and cleats affixed to the bottom side to hold them in place, and then varnished. Turns out they make sort of handy "butler's trays" when used upside down at anchor.

Making a set of "usable mock-up from scrap" cover boards for the sink and former-Wallas hole in the galley counter. Two sheets of scrap 1/8" ply epoxied together to make 1/4", then cut and cleats affixed to the bottom side to hold them in place, and then varnished. Turns out they make sort of handy "butler's trays" when used upside down at anchor.

Board made utilizing some scraps to fill the hole from the Wallas (removed and sold). Just some scrap 1/8" ply epoxied together to make 1/4", then cut out, some cleats stuck to the bottom side, and then varnished.

Princess butane drop-in stove, flat stainless lidded version (other version has wooden cutting board that sits on top).

Princess butane drop-in stove, flat stainless lidded version (other version has wooden cutting board that sits on top).

14 There are three contoured supports like this supporting it all

12 this is how it gets back to the place where it goes across to port

11 water line runs along hull side out of the way

S

Making a set of "usable mock-up from scrap" cover boards for the sink and former-Wallas hole in the galley counter. Two sheets of scrap 1/8" ply epoxied together to make 1/4", then cut and cleats affixed to the bottom side to hold them in place, and then varnished. Turns out they make sort of handy "butler's trays" when used upside down at anchor.

Sunbeam
Jun 2, 2015

There are no comments to display.

Top