Looking aft without forward dinette seat in place. Had to remove it to properly template that area, trim the material, and glue it in place. The hatch hinges will also assist in holding the dinette section in place. The cabin floor section is floating.

100W Solar Panel installed by Wefings

Small step at helm. This section is also glued down.

Looking towards the bow without the forward sliding dinette seat in place

Looking aft without forward dinette seat in place. Had to remove it to properly template that area, trim the material, and glue it in place. The hatch hinges will also assist in holding the dinette section in place. The cabin floor section is floating.

Finished product, ready to use. The material is made by Lonseal Marine, Teak & Holly 70SE. It comes in a 6' wide roll, cut to whatever length you desire.

Drawers had no lock, so we made one... Now we can drop table and nothing falls out.

two under table drawers from campingworld

M

Looking aft without forward dinette seat in place. Had to remove it to properly template that area, trim the material, and glue it in place. The hatch hinges will also assist in holding the dinette section in place. The cabin floor section is floating.

maryvmcclain
Jan 19, 2014

There are no comments to display.

Top