Prev
Just slid down over tilt rod. On our 150 hp motor there is a grease fitting that can interfere so we always use the port tilt rod
Next
Prev
More protective tubing to protect brake lines
Note brake hoses sleeved in clear plastic tubing and tie wrapped to prevent rub through.
Lower motor until you squish the hard rubber a little and then trailer away
Just slid down over tilt rod. On our 150 hp motor there is a grease fitting that can interfere so we always use the port tilt rod
Just tilt motor up all the way
New to us Yamaha Motor stop for trailering
replaced cable with chains reused snap hooks
Next
W

Just slid down over tilt rod. On our 150 hp motor there is a grease fitting that can interfere so we always use the port tilt rod

  • Media owner Will-C
  • Date added
Just slid down over tilt rod. On our 150 hp motor there is a grease fitting that can interfere so we always use the port tilt rod
Click to expand...
There are no comments to display.

Media information

Category
Trailer Mods
Album
P1000486 Some scrap 3 x 4" aluminum angle 1/2" stainless u-bolt 35 dollar stainless turnbuckle, short piece of chain, and a shackle.
Added by
Will-C
Date added
View count
4
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top