Prev
I also added a little washer of butyl tape to each one and didn't turn the screw head once it made contact.
Next
Prev
I got this far and walked away until the next day - then I gave each nut the same extra half turn to snug it up a little more.
Once the butyl tape started to compress I was diligent about tightening the nuts equally as I went around so as not to tork the frame or get unequal compression.
On the left is one of the two machine screws that hold the hinges
I also added a little washer of butyl tape to each one and didn't turn the screw head once it made contact.
The hatch was previously fastened with wood screws (they only threaded the top layer of solid fiberglass and dug into the balsa core. I replaced them all with machine screws washers and nyloc nuts.
It goes around the corners just fine.
I used butyl tape (two layers in this application) from Sailrite to bed the frame.
Next
S

I also added a little washer of butyl tape to each one and didn't turn the screw head once it made contact.

  • Media owner sebastien
  • Date added
I also added a little washer of butyl tape to each one and didn't turn the screw head once it made contact.
Click to expand...
There are no comments to display.

Media information

Category
Front hatch repair
Album
The main hatch has has been leaking for a while but I wanted to get off the great lakes before taking it apart (I made a quick and dirty rain cover that attached into the four existing snaps for the sun shade)
Added by
sebastien
Date added
View count
2
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top