Prev
I added a layer of 3/4" foil backed closed cell foam insulation to further reduce heat intrusion.
Next
Prev
This project involved converting the cavernous space under the Port dinette seat of our 25 into drawer (bin type) storage. Shown with drawer guides in place.
This was a fun project (although I'm broke now). Total cost was $590 Excluding the extra battery. I chose the Tundra because it was a bit cheaper than Novacool or Isotherm; had a great service network (Dometic); and used the latest Danfoss compressor.
Finished unit installed and ready for testing. Thanks for looking!
I added a layer of 3/4" foil backed closed cell foam insulation to further reduce heat intrusion.
Vent louvers. Proper venting was the number one tip that the techs. mentioned.
Vents located under the helm. one is 15" by 2" the hole is 4" in diameter. The top vent is located next to the compressor fan (exhaust side).
Ventilation for the refrigerator. 50 in. Sq. minimum required. This is a 4 1/2 inch hole located under the sink.
Next
M

I added a layer of 3/4" foil backed closed cell foam insulation to further reduce heat intrusion.

  • Media owner My IRA
  • Date added
I added a layer of 3/4" foil backed closed cell foam insulation to further reduce heat intrusion.
Click to expand...
There are no comments to display.

Media information

Category
Winter 2005 project upgrages to "Scooter".
Album
The hanging locker that wasn't tall enough to hang clothes in.
Added by
My IRA
Date added
View count
2
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top