Prev
Extra table brackets to hold seat in standard position and aft position. Only two of us and I didn't want to cut table or loose drawer under top.
Next
Prev
Seat moved aft. Wooden bumper installed on bulkhead keeps seat box from rubbing on bolt heads below. Bin front end is in center of photo.
Table in aft position over the top of the rear seat. This setup blocks use of the rear seat when the Barber Chair faces forward.
Side bin with slot. Bin runs under gunnel between aft seat front and forward bulkhead. Seat T bar runs back and forth in track.
Extra table brackets to hold seat in standard position and aft position. Only two of us and I didn't want to cut table or loose drawer under top.
Aft end of forward seat. Slot in mahogany is slide for poly T shaped piece that is fastened onto sliding seat box. Mahogany is bin.
Stainless hasp with TyBoo gizmo below with the locking knob in place. Knobis counter sunk into edge of new floor and hasp is on seat face.
Stainless steel hasp with the TyBoo gizmo below. The threaded female section is for the knob that locks chair in place.
Next
L

Extra table brackets to hold seat in standard position and aft position. Only two of us and I didn't want to cut table or loose drawer under top.

Extra table brackets to hold seat in standard position and aft position. Only two of us and I didn't want to cut table or loose drawer under top.
Click to expand...
There are no comments to display.

Media information

Category
Lynn Marie
Album
533564-R1-10A.jpg
Added by
Lynn Marie
Date added
View count
4
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top