Prev
depth of the slot (I think I made the front and back the same in the end even though the chamfer runs off level a little)
Next
Prev
with the 4in. thick cushion it's a fairly standard seating height but creates a good amount of space underneath
the aft bracket length is shorter than the bow one because the the c-dory has a slightly pinched shape (also note the higher you go the wider it gets too)
I used PVC wood stuff from lowes for the back retaining pieces (the extra hole is for the fresh water fill cap on the porta potti that was too high after deciding to install dri-dek - whoops
depth of the slot (I think I made the front and back the same in the end even though the chamfer runs off level a little)
IMG 1638
overall measurement of each bracket
each 1/2 MDO panel is 24x24
Next
S

depth of the slot (I think I made the front and back the same in the end even though the chamfer runs off level a little)

  • Media owner sebastien
  • Date added
depth of the slot (I think I made the front and back the same in the end even though the chamfer runs off level a little)
Click to expand...
There are no comments to display.

Media information

Category
kockpit settee
Album
setting up the MDO bracket for the slots
Added by
sebastien
Date added
View count
2
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top