Prev
As 20 gals of water weighs 160 lbs, I used 3/4 marine ply and heavy duty aluminum angle bolted to the bulkheads.
Prev
I never liked the sight tube level gauge as I had a hard time reading it. The panel slides up revealing the tank, an easy read.
The original tank was pulled to make room for the AC unit. I used a bladder tank in a couple different locations, but it just did not work out. Moving the original tank forward took some weight off the stern and was an easy job.
Easy fit. I extended the fill and vent tubes to use the original fill location.
As 20 gals of water weighs 160 lbs, I used 3/4 marine ply and heavy duty aluminum angle bolted to the bulkheads.
Next
A

As 20 gals of water weighs 160 lbs, I used 3/4 marine ply and heavy duty aluminum angle bolted to the bulkheads.

  • Media owner anchorout
  • Date added
As 20 gals of water weighs 160 lbs, I used 3/4 marine ply and heavy duty aluminum angle bolted to the bulkheads.
Click to expand...
There are no comments to display.

Media information

Category
RELOCATE 20 GAL WATER TANK.
Album
The original tank was pulled to make room for the AC unit. I used a bladder tank in a couple different locations, but it just did not work out. Moving the original tank forward took some weight off the stern and was an easy job.
Added by
anchorout
Date added
View count
3
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top