Prev
after feathering it out some to fit the housing perfectly, silicon was recommended to seal, before filling the outer cavity with glass and resin...
Next
Prev
about the half-way-point in the Classic hull, works great in this spot for speeds under 13 knots or so.
filled with antifreeze
arrg! there it is :D
after feathering it out some to fit the housing perfectly, silicon was recommended to seal, before filling the outer cavity with glass and resin...
carved out with a hole saw and finished with a vibratory power tool with sanding disc and rasp - also shown is the coat of glass and resin to seal it up.
Transducer location preferred inside under Force 10 heater, not pictured.
internals of clinometer.
Next
C

after feathering it out some to fit the housing perfectly, silicon was recommended to seal, before filling the outer cavity with glass and resin...

  • Media owner cbadmin
  • Date added
after feathering it out some to fit the housing perfectly, silicon was recommended to seal, before filling the outer cavity with glass and resin...
Click to expand...
There are no comments to display.

Media information

Category
Electronics
Album
2006C View from above.jpg
Added by
cbadmin
Date added
View count
4
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top