Prev
4. Added "Mini Fibers" to System Three Cold Cure epoxy to thicken mix for holding on a verticle surface. Filled holes with two coats of epoxy.
Next
Prev
5. Holes ready to fill with epoxy.
5. Inside of drain plug hole filled in with epoxy. Drain plug in place.
5. Cockpit Floor Fastener Improvements
4. Added "Mini Fibers" to System Three Cold Cure epoxy to thicken mix for holding on a verticle surface. Filled holes with two coats of epoxy.
4. View drain plug from the inside with epoxy applied and drain plug in place.
4. Starboard side ready to reinstall hardware. There was some air bubbles, shrinkage or seapage of the epoxy into the foam core, so it took two applications of epoxy.
3. Number 10 screws drilled out with 3/8" drill bit, then additional yellow closed cell foam around the inside of the 3/8" hole removed with a "Dremel". 3/8" Swim step bolt holes redrilled out to 7/16".
Next
R

4. Added "Mini Fibers" to System Three Cold Cure epoxy to thicken mix for holding on a verticle surface. Filled holes with two coats of epoxy.

4. Added "Mini Fibers" to System Three Cold Cure epoxy to thicken mix for holding on a verticle surface. Filled holes with two coats of epoxy.
Click to expand...
There are no comments to display.

Media information

Category
Fastener Improvements 2009 23 Venture "Pacific Wanderer"
Album
1. Cockpit Floor Fastener Improvements. All original No. 10 screws and hardware still in place before starting improvements.
Added by
ross_ballard
Date added
View count
3
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top