Prev
2. Drain plug hole Dremeled out and ready to receive epoxy.
Next
Prev
3. You can see the yellow closed cell foam core.
3. Port side of cockpit, ahead of the fuel tank. The holes have now been filled with "System Three" Cold Cure epoxy. I used a syringe to fill the bottom of the hole first, and work the air to the top and out.
2. Transom Fastener Improvements
2. Drain plug hole Dremeled out and ready to receive epoxy.
2. I used a 3/8" drill bit to drill through the top of the cockpit deck fiberglass down through the dark grey foam core to touch the bottom layer of the laminated deck. I then took a "Dremel" and hollowed out a greater amount of foam core below the top deck layer of fiberglass to give a greater area to fill in with epoxy.
1. Transom Fastener Improvements. Swim step, transducer, trim tabs removed.
1. Drain Plug removed.
Next
R

2. Drain plug hole Dremeled out and ready to receive epoxy.

2. Drain plug hole Dremeled out and ready to receive epoxy.
Click to expand...
There are no comments to display.

Media information

Category
Fastener Improvements 2009 23 Venture "Pacific Wanderer"
Album
1. Cockpit Floor Fastener Improvements. All original No. 10 screws and hardware still in place before starting improvements.
Added by
ross_ballard
Date added
View count
2
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top