Prev
012 12 The end cap was fairly corroded. A little elbow grease and sanding sponge brought it back pretty well
Next
Prev
015 15 5200 lumps by Helm Station
014 14 More 5200 lumps after tapping with hammer and piece of pipe. Starboard side of berth.
013 13 Lump of 5200 after I tapped them with a hammer and piece of 5/8" thin wall pipe. Made a pretty good plug
012 12 The end cap was fairly corroded. A little elbow grease and sanding sponge brought it back pretty well
011 11 More rivet shafts to be removed
010 10 The gap between the top and bottom halves of the boat was consistently about 1/8"
009 9 After drilling out the remaining rivet washers, I pulled the rail free and you can see the rivet shaft and the fiberglass fluff in the joint. I sanded this fluff off after all rivet shafts were removed
Next
T

012 12 The end cap was fairly corroded. A little elbow grease and sanding sponge brought it back pretty well

012 12
The end cap was fairly corroded. A little elbow grease and sanding sponge brought it back pretty well
Click to expand...
There are no comments to display.

Media information

Category
Rub Rail Project
Album
001 1 Starboard side separation looking forward
Added by
Tad and Toby Jackson
Date added
View count
3
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top