Online prop supplier?

C-Val · Posted: Sun Jun 30, 2013 12:09 am Post subject: Online prop supplier?

Time for me to draw on the collective wisdom of our fellow brats!

My last run with my 1982 Johnson 70 hp 2 stroke (which is on my 22' Angler) would only give me 4800 rpm at wot with normal load.

My current prop is 13 3/4 by 15
My thoughts are I need to prop down to a 13 3/4 by 13 to try to get up to 5500 Does this seem right to you?

Its seems hard to find an online supplier who has this diameter in 13" pitch
Any suggestions?

As a footnote:
I just installed a permatrim and lifted the engine as high as I can. AV plate is very close to bottom of now ( 1/2" below) There is still water over it at full speed but that is as high as I can go without re-drilling. I don't know how much that may affect things???

Any thoughts?

PeterQ · Posted: Sun Jun 30, 2013 12:32 pm Post subject:

Sounds like you are on the right track, but if you want online recommendations and possibly a test prop, you could visit the propgods web site.

Pete

C-Val · Posted: Sun Jun 30, 2013 1:43 pm Post subject:

Thanks Pete will do