Reversible seating - CD22

Sealife · Posted: Fri May 26, 2006 5:40 pm Post subject:

Mark,

I'd appreciate the pictures. My email address is brode2@aol.com.

How did you afix the wood strip...5200 or screws?

Thanks much.

Mighty Bite · Posted: Sun May 28, 2006 2:28 am Post subject:

5200 and screws (7). Don't stand short in the land of plenty!

Sealife · Posted: Thu Jun 29, 2006 8:21 pm Post subject:

Mark,

Installed the new hardware hinges, but elected to fasten directly to the bulkhead without the teak board. The teak board would have moved the table outward toward the isle a bit, requiring repositioning of the table leg, and I found the fit of the table against the bulkhead was better than against the board because the bulkhead has a slight curve. The table had been trimmed to fit this curve. The upshot is it works....solid. One question though. I haven't been able to figure out the purpose or the positioning of the black lever gadget? I've studied your picture and still can't figure it out. Help?