Bomar hatch seals replacement?

Montana Kev · Posted: Tue Sep 04, 2012 11:11 pm Post subject: Bomar hatch seals replacement?

I have been searching thru the site looking for info on where to order a replacement Bomar hatch seal to fit the front hatch over the birth. Can these be ordered direct from Bomar or West Marine?

Thanks,
Kevin

Sunbeam · Posted: Tue Sep 04, 2012 11:30 pm Post subject:

I think you may find some helpful information in this thread:

http://www.c-brats.com/viewtopic.php?t=18155

The part numbers are specific to the OP's hatch serial number (which may or may not cover yours), but the contact/Bomar information could help.

Sunbeam Hot

Montana Kev · Posted: Wed Sep 05, 2012 10:49 am Post subject:

Sunbeam,

Thanks, that thread has some good contact information.

Kevin

Tad and Toby Jackson · Posted: Thu Sep 06, 2012 1:59 pm Post subject:

Kevin,

I purchased a new lens for the Bomar Hatch on our 22' cruiser.. I also had to purchase a new gasket for the hatch. Unfortunately, they sent out the low profile gasket which will not work on my hatch #. I contacted customer service and they immediately saw their mistake and sent out the high profile gasket. Very good service. Hatch model # is stamped on the inside of the aluminum frame toward the rear as I remember.
Bomar is a subsidiary of Pompanette.

NH Plant: 603-826-5791 Also number for Customer Service
FL Plant: 813-885-2182

Good Luck...Tad

Montana Kev · Posted: Thu Sep 06, 2012 11:29 pm Post subject:

Thanks Tad. Have this on my do list. Season is winding down here in MT. Frost on the docks, birds are heading south.

Cheers,
Kevin