Prop help

Surveyor1 · Posted: Sat Jul 09, 2022 7:57 pm Post subject: Prop help

So my new Honda 90 is on my boat!
But it’s still in the shop.
What’s the consensus as to the best prop?
As a reminder, it’s a CD22.

ssobol · Posted: Sat Jul 09, 2022 11:47 pm Post subject:

I use a 3 blade 13.5 x 15 aluminum prop on my BF90D.

Surveyor1 · Posted: Sun Jul 10, 2022 11:25 am Post subject:

Thanks, is that normally stated as PxD or DxP?

C-Wolfe · Posted: Sun Jul 10, 2022 12:48 pm Post subject:

Standar is DxP.

jrassier · Posted: Wed Jul 13, 2022 10:30 am Post subject:

This aluminum $120 prop (Turning Point Hustler 4 Blade 13.5x 15) delivers 24Kts /6200 RPM at WOT on our 22 Cruiser/BF90 lightly loaded. And 15Kts/ 4.500 RPM 4 blade props have better reverse thrust, more lift/better hole shot than 3 blade screws, generally a 3 blade will have a bit more top end speed.

thataway · Posted: Wed Jul 13, 2022 1:03 pm Post subject:

We have run the 13.5 x 15 on all of our 22'2 at sea level. We have gone as low as 13.75 x 11 at Lake Powell (about 3700 feet when full). with a loaded boat. We will see very close to 30 mph with a light boat--and as low as 18 mph with a heavy loaded boat. We do recommend that all boats have both trim tabs and Permatrim foil installed to get the best handling, especially going int chop.

djy887 · Posted: Wed Jul 13, 2022 1:18 pm Post subject:

Bob, would you say the 13.5 x 15 prop is good option for the same Honda 90's in a twin configuration on a TC that is typically run without a heavy load?

Molly Brown · Posted: Thu Jul 14, 2022 6:29 am Post subject:

On our TC24 with Suzuki 90's we run that prop in a 4 blade stainless, 13.5X15

James

thataway · Posted: Thu Jul 14, 2022 3:54 pm Post subject:

Surveyor1 · Posted: Fri Jul 15, 2022 9:49 pm Post subject:

So I took delivery of my new motor today and it came with a 13.5x15.