View previous topic :: View next topic |
Author |
Message |
mkendrick
Joined: 27 Jul 2011 Posts: 13 City/Region: White Stone
State or Province: VA
C-Dory Year: 2006
C-Dory Model: 25 Cruiser
Vessel Name: Nickel 'N' Dymer
Photos: Nickel 'N' Dymer
|
Posted: Thu Apr 04, 2019 9:26 am Post subject: Replacing Bow Hatch for C-Dory 25 - 2006 |
|
|
I have water linking into the v-berth. While inspecting the problem I have discovered that there is a substantial crack in the hatch. Where can I get a replacement hatch for a 2006 - 25? Is it difficult to replace? _________________ Mickey and Beth Kendrick |
|
Back to top |
|
|
srbaum
Joined: 30 Aug 2010 Posts: 877 City/Region: Portsmouth
State or Province: VA
C-Dory Year: 2007
C-Dory Model: 26 Venture
Vessel Name: Osprey
Photos: Osprey
|
Posted: Thu Apr 04, 2019 12:02 pm Post subject: |
|
|
Mickey & Beth,
Give me a call. Replacement of the Lexan is straight forward and inexpensive.
757-477-1453 _________________ Steve Baum
Homeport of Portsmouth, VA
OSPREY (Ex Mister Sea) 2000 22 C-Dory 2010 - Sold 3/19
OSPREY (Ex ADITI) 2007 26 Cape Cruiser 2018 |
|
Back to top |
|
|
thataway
Joined: 02 Nov 2003 Posts: 20813 City/Region: Pensacola
State or Province: FL
C-Dory Year: 2007
C-Dory Model: 25 Cruiser
Vessel Name: thataway
Photos: Thataway
|
Posted: Thu Apr 04, 2019 1:30 pm Post subject: |
|
|
The Lens of the hatch is available both from Bomar and from various on line suppliers. The sealant is a special silicone. Getting the Lexan lens exactly in the correct location is critical. Also local suppliers can make a lens--but it is critical where the holes for the dogs are placed.
One of the attendees at Hontoon had recently replaced his lens, and the hatch leaked because the dogs were not in the proper location, and the gasket was deformed.
The old sealant can be cut out with a wire or braid between two wooden handles. A few have replaced with safety glass--There are disadvantages to this in my opinion.
Lexan will scratch and can be degraded by UV. There are coatings which mitigate this to some degree. My boat has a thin layer of white Starboard over the hatch, and a solar water tight vent installed, which promotes air circulation in the boat. _________________ Bob Austin
Thataway
Thataway (Ex Seaweed) 2007 25 C Dory May 2018 to Oct. 2021
Thisaway 2006 22' CDory November 2011 to May 2018
Caracal 18 140 Suzuki 2007 to present
Thataway TomCat 255 150 Suzukis June 2006 thru August 2011
C Pelican; 1992, 22 Cruiser, 2002 thru 2006
Frequent Sea; 2003 C D 25, 2007 thru 2009
KA6PKB
Home port: Pensacola FL |
|
Back to top |
|
|
Yakmandu
Joined: 03 Nov 2017 Posts: 70 City/Region: Lake Lanier
State or Province: GA
C-Dory Year: 2005
C-Dory Model: 19 Angler
Vessel Name: Miss April
Photos: Pops GO!
|
Posted: Thu Apr 04, 2019 7:39 pm Post subject: |
|
|
I just replaced my cracked hatch lens on my 2005 19 Angler. I emailed Bomar with the serial number I found on the inside of the hatch cover. I ordered a replacement lens, gasket, and sealer from Bomar. Followed the directions and the project was a success. Customer service at Bomar was top notch! _________________ Patrick Rohde
Miss April
Lake Lanier, GA |
|
Back to top |
|
|
Yakmandu
Joined: 03 Nov 2017 Posts: 70 City/Region: Lake Lanier
State or Province: GA
C-Dory Year: 2005
C-Dory Model: 19 Angler
Vessel Name: Miss April
Photos: Pops GO!
|
Posted: Thu Apr 04, 2019 7:59 pm Post subject: |
|
|
Yakmandu wrote: | I just replaced my cracked hatch lens on my 2005 19 Angler. I emailed Bomar with the serial number I found on the inside of the hatch cover. I ordered the replacement lens and gasket from Bomar, and the recommended sealer from Amazon. Followed the directions and the project was a success. Customer service at Bomar was top notch! |
|
|
Back to top |
|
|
hardee
Joined: 30 Oct 2006 Posts: 12632 City/Region: Sequim
State or Province: WA
C-Dory Year: 2005
C-Dory Model: 22 Cruiser
Vessel Name: Sleepy-C
Photos: SleepyC
|
Posted: Fri Apr 05, 2019 4:59 pm Post subject: |
|
|
Yakmandu wrote: | I just replaced my cracked hatch lens on my 2005 19 Angler. I emailed Bomar with the serial number I found on the inside of the hatch cover. I ordered a replacement lens, gasket, and sealer from Bomar. Followed the directions and the project was a success. Customer service at Bomar was top notch! |
yakmandu, do you have the email address you used to contact Bowmar? I have not found the right place .... yet.
Thank you,
Harvey
SleepyC
_________________ Though in our sleep we are not conscious of our activity or surroundings, we should not, in our wakefulness, be unconscious of our sleep. |
|
Back to top |
|
|
Yakmandu
Joined: 03 Nov 2017 Posts: 70 City/Region: Lake Lanier
State or Province: GA
C-Dory Year: 2005
C-Dory Model: 19 Angler
Vessel Name: Miss April
Photos: Pops GO!
|
Posted: Fri Apr 05, 2019 6:02 pm Post subject: |
|
|
Here is the contact email address... bomar@pompanette.com
Here is the reply I got when I first inquired. It was very detailed and complete. I highly recommend their customer service! Of course, you will need to provide YOUR serial number to get the right replacement lens.
覧覧覧覧覧覧覧覧覧
Thank you for your email. I was able to look up the serial number number the hatch is an N1039-10A this hatch has a clear anodized frame with a smoked lens...the outer dimension of the base of the hatch is 21 13/16 X 21 13/16.. the price on a complete new hatch is $623.00 with a 3 to 4 week lead time. I am sorry we do not offer the lid only to any of our hatches. You can purchase just the lens, the part number for that is P2000-82-1039 with a price of $132.00 with a 4 week lead time.
If you do decide to order the lens only the product that we suggest using to float the lens is called General Electric Ultra Glaze our part number for this in black is P100-75 with a price of $39.00. We do also suggest changing out the gasket in our hatches every 8 to 10 years and the easiest time to do that is when the lens is out of the frame, the part number for the gasket for this hatch is P2000-09 with a price of $7.00 per foot. For this hatch you will need to purchase 7 feet.
To this email I have attached the instructions on how to put in the new lens and how to install the lip gasket for your review.
You can order what you are in need of from us by filling out and returning the attached order form or by calling Customer Service at 603-826-5791. You could also purchase from West Marine, Land N Sea, Defender Industries, Go 2 Marine, or Sailboat Owners.
Best, NELL
Best regards,
Bomar Customer Service Rep.
603-826-5791 |
|
Back to top |
|
|
hardee
Joined: 30 Oct 2006 Posts: 12632 City/Region: Sequim
State or Province: WA
C-Dory Year: 2005
C-Dory Model: 22 Cruiser
Vessel Name: Sleepy-C
Photos: SleepyC
|
Posted: Fri Apr 05, 2019 9:11 pm Post subject: |
|
|
Thank you for all that info. I don't need to replace the lens, but I would like to replace the gasket or "O" rings for the latches.
Harvey
SleepyC
|
|
Back to top |
|
|
|