lmf-200 just flashing ---

chewyjackson · Joined: 29 Apr 2006 Posts: 29

I finally finished the install on my fuel flow meter.

Will it give you a reading at idle? I'm just getting a flashing --- and nothing else.

Thanks in advance

mikeporterinmd · Posted: Wed Apr 25, 2007 10:39 pm Post subject:

Did you initialize the EP-10? Are you connected to an EP-10? An
LGC-2000? Which gauge is flashing (which page). What is flashing?

Mike

chewyjackson · Joined: 29 Apr 2006 Posts: 29

I think I haven't initialized it. I re-read the crappy instruction manual.

I thought when I set it up (fuel level, tank capacity), that that was the initialization.

Upon further reading, I think I missed a step.

The --- is in the fuel flow page where it should display the GPH.

I'm walking downstairs to go check it out in a bit.